Wood Working project plan

 when last we visited this project back in september, the carpenters had just finished getting the slate on the roof ... after that it was on to the siding and window trim outside, and the insulation, second floor radiant heat,and sheetrock inside.  click the photos to enlarge them ..

the shed is fitted here with a bronze color standing seam roof by donnie dorrs metal shop ..

 and inside, we did some painting, and reconfigured the chop saw tables into a mockup work table so we could figure out where to hang up the welding fume extractor.  we ran the pipes to the blower thursday ..

 boilers these days are amazing ... this little guy puts out 80,000 btus, enough to heat both floors, (+/- 1500 square feet in a vemont winter), and provide domestic hot water for the sink and bathroom.  exhaust out in pvc pipe.  no chimney ...

 ahhh, the doors .. nobody made a cheap standard unit three doors wide, so we had to cobble these together with parts from a company whose name escapes me now .. we made up some quicky transoms from 8/4 pine and ordered up some custom thermopane to fill them.

 there were a couple reasons for that configuration .. #1, you can open the doors totally in the summer like below, and should we move on at some point, the openings are framed to accept regular 9 x 7 commercial overhead doors .. presto, a heated, two car garage with a mother in law apartment above  ... the plumbing and radiant for the second floor was roughed in before the sheetrock went up ..

 

 a few notes below on the quicky transoms ...

 9 3" x 16" plus the frames

 essentially, the frames are butt jointed, timberlock construction, with applied moldings to accept the glass .. framed in the shop and screwed in over the door units .. cheap, easy, and fast ... you dont get that combo often enough ...

all for now ... sam is moving in this week